Carrier 38TXA Guide Betriebsanweisung PDF herunterladen (Seite 161)

Chapter 4 161

Parameter Descriptions

3. CPA Enter Ph# [0=If Needed,1=Always,Here]

This parameter specifies from where the test will get the phone number

of the MSUT. You may enter one of three options:

• 0

• 1

• the 10 digit phone number of the MSUT

Setting this parameter to 0=If Needed tells the Test Set to prompt the

user for the phone number of the MSUT if:

• The phone number is needed to perform the first test in a test

sequence, AND

• A MIN was not obtained by the Test Set running a previous test

procedure.

Setting this parameter to 1=Always,tells the Test Set to prompt the

user for the phone number of the MSUT each time the test procedure is

run. (Note that if parameter 4. CPA MIN From? [0=RECC,1=All

0’s,2=Phone #] is set to 1=All 0’s indicating an all zero MIN, the user

is not prompted for a phone number). Setting parameter 3 to anything

other than 0=If Needed or 1=Always will cause the Test Set to use the

number entered as a ten digit phone number for paging the MSUT if

one of the following conditions are also true:

• parameter 4. CPA MIN From? [0=RECC,1=All 0’s,2=Phone #] is set

to 2=Phone #, indicating to the Test Set to get the MIN from the

phone number.

• parameter 4. CPA MIN From? [0=RECC,1=All 0’s,2=Phone #] is set

to 0=RECC and a MIN has not been previously entered into the Test

Set by running a previous test

procedure.

Example

If parameter 3 is set to 1231234567 and parameter 4 is set to 2=Phone#,

the Test Set will use a MIN corresponding to phone number

123-123-4567 to page the MSUT.

NOTE

If a registration or an origination is performed that causes a new MIN

to be entered into the test, this new MIN will then be used instead of

the MIN derived from the entered phone number.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 213 214

Keine Kommentare

Carrier 38TXA Guide Betriebsanweisung Seite 161