Carrier operating and maintanance Spezifikationen PDF herunterladen (Seite 33)

5-376-000097

REV. 1 - 12/08

Section I: Safety

Page 23

012

WARNING

WINCH CABLE FAILURE MAY CAUSE INJURY OR DEATH. STAY CLEAR OF CABLE

AND LOAD WHEN OPERATING.

BOTH FRONT AND REAR TIE DOWNS MUST BE USED TO SECURE VEHICLE / LOAD

TO DECK. DO NOT RELY ON THE WINCH AS THE ONLY MEANS OF HOLDING THE

LOAD.

CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING

OPERATION.

DO NOT DISENGAGE CLUTCH UNDER LOAD.

DO NOT USE WINCH TO LIFT, SUPPORT OR OTHERWISE TRANSPORT PEOPLE.

A MINIMUM OF 5 WRAPS OF CABLE AROUND THE WINCH DRUM IS NECESSARY TO

HOLD THE LOAD. CABLE SETSCREW IS NOT DESIGNED TO HOLD LOAD.

DO NOT EXCEED MAXIMUM LINE PULL RATINGS PUBLISHED IN EQUIPMENT

OPERATOR'S MANUAL AND / OR WINCH OPERATING MANUAL.

WARNING

139

HAVE YOU REVIEWED THE

OPERATOR'S PRE-TRANSPORT

CHECK LIST ON THE UNIT?

CAUTION

AIR SUSPENSION MUST BE FULLY

DEFLATED BEFORE TILTING DECK

TO LOAD OR UNLOAD

AIR SUSPENSION MUST BE FULLY

DEFLATED BEFORE TILTING DECK

TO LOAD OR UNLOAD

176

GUIDE

BUSHING

242

WARNING

*TO ENGAGE WINCH: LIFT UP KNOB THEN

RELEASE. OPERATE WINCH TO ENGAGE

CLUTCH.

*TO FREE SPOOL WINCH: RUN WINCH IN

IS OFF THE CABLE. LIFT UP KNOB AND

*BEFORE OPERATION: WINCH CLUTCH MUST

BE COMPLETELY ENGAGED WITH GUIDE

BUSHING POSITIONED AS SHOWN.

REVERSE (REEL OUT) UNTIL THE LOAD

PULL OUT. LOCK IN PLACE.

DO NOT FREE SPOOL UNDER LOAD.

WARNING

274

DO NOT EXCEED TOW OPTION

CAPACITIES. OVERLOADING MAY

RESULT IN UNSAFE STEERING

AND/OR BRAKING CONDITIONS.

CAUTION

330

DO NOT INSTALL OR REMOVE DECK FROM

SUBFRAME WITH ORBIT MOTOR FITTINGS

INSTALLED.

WINCH ORBIT MOTOR FITTINGS WILL

INTERFERE WITH NYLON CABLE TRACK.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 115 116

Kommentare zu diesen Handbüchern

Keine Kommentare

Carrier operating and maintanance Spezifikationen Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Carrier operating and maintanance