Carrier 40KMQ Spezifikationen PDF herunterladen (Seite 9)

MOUNTING THE ROOM CONTROLLER (Fig. 15-17) —

Unscrew the side fixing screw. Open the room controller rear

mounting base to expose the mounting holes. The base can be

removed to simplify mounting (snap apart carefully at hinge to

separate mounting base from the rest of the room controller).

Route the room controller wires through the large hole in the

mounting base. Level the mounting base against the wall (for

aesthetic value only, as the room controller does not need to be

level for proper operation) and mark the wall through the two

mounting holes. Drill two

in. mounting holes in the wall

where marked. Secure the mounting base correctly (UP) to the

wall with the two screws and two anchors provided, (additional

anchoring holes are available for more secure mounting if nec-

essary) making sure all wires extend through the hole in the

mounting base. Adjust the length and routing of each wire to

reach the proper terminal in the connector block on the mount-

ing base, with

in. of extra wire (strip only

in. of insulation

from each wire to prevent adjacent wires from shorting togeth-

er when connected).

Match and connect equipment wires to proper terminals

in the connector block. Both power and communication

wires must be connected correctly for proper room controller

operation.

Push any excess wire into the wall and against mounting

base. If the air sensor is being used on the room controller, seal

the hole in the wall to prevent air leaks. Leaks can affect sensor

operation.

Push the room controller snap hinge to the base and tighten

the side fixing screw.

4-1/4" (108mm)

0mm)7("4/3-2

3/4"(20mm)

Fig. 14 — Room Controller Dimensions

Mounting screws

Fig. 15 — Mounting the Room Controller

Connection Cable

Fig. 16 — Locating the Connection Cable

Fig. 17 — Connecting the Room Controller

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

Carrier 40KMQ Spezifikationen Seite 9