Carrier 8DF-13 Betriebsanweisung PDF herunterladen (Seite 22)

2. Setup

SMC-4DF-PCI, SMC-8DF-PCI

Setting the Board ID

If you install two or more boards on one personal computer, assign a different ID value to each of the

boards to distinguish them.

The board IDs can be set from 0 - Fh to identify up to sixteen boards.

If only one board is used, the original factory setting (Board ID = 0) should be used.

Setting Procedure

To set the board ID, use the rotary switch on the board. Turn the SW1 knob to set the board ID as shown

below.

BOARD ID

SW1

(Board ID = 0)

Factory setting:

Figure 2.3. Board ID Settings (SW1)

Setting the Terminating Resistor

You can select whether to insert a terminator (terminal resistor) in the differential input section.

Select whether to insert the terminator depending on the system to be used.

Setup Method

To select whether to insert the terminator, use the DIP switches (SMC-4DF-PCI : SW2 and SW3,

SMC-8DF-PCI : SW2 - SW5) on the board.

Set each SW according to the figure shown below.

SMC-8DF-PCI :

SMC-4DF-PCI :

SW2

12345678

Axis6

Axis0

Axis7

Axis1

SW3

12345678

Axis4

Axis2

Axis5

Axis3

SW4

12345678

Axis2 Axis3

Factory setting : All is ON

SW5

12345678

Axis0 Axis1

Bit

Input

signal

Insert the terminal Not insert the terminal

1 Phase-A ON OFF

2 Phase-B ON OFF

3 Phase-Z ON OFF

4 N.C. ---- ----

5 Phase-A ON OFF

6 Phase-B ON OFF

7 Phase-Z ON OFF

8 N.C. ---- ----

Figure 2.4. Terminator Setup SW and Settings

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 74 75

Kommentare zu diesen Handbüchern

Keine Kommentare

Carrier 8DF-13 Betriebsanweisung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Carrier 8DF-13