Carrier Edge TP-PHP Bedienerhandbuch PDF herunterladen (Seite 22)

Single--Piece Installation

The following steps should be followed for the installation of the single--piece

configuration.

1. Remove cover from Equipment Control Module by pressing the two tabs on

the bottom edge and pulling away. Route wires through large hole in Equip-

ment Control Module. Level Equipment Control Module against wall (for

aesthetic value only -- Equipment Control Module need not be leveled for

proper operation) and mark wall through 4 mounting holes. To avoid unin-

tended bending of wall plate plastic, use all 4 screws and anchors.

2. Drill four 3/16--in. mounting holes in wall where marked. Thermostat may

be mounted to a standard junction box if desired. Hole pattern on Equip-

ment Control Module matches junction box mounting holes.

3. Secure rear plastic Equipment Control Module to wall with 4 screws and

anchors provided. To avoid unintended bending of wall plate plastic, use all

4 screws and anchors. Make sure all wires extend through hole in Equip-

ment Control Module.

4. Adjust length and routing of each wire to reach proper connector block and

terminal on Equipment Control Module with 1/4--in. (6 mm) extra length.

See Fig. 15.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Keine Kommentare

Carrier Edge TP-PHP Bedienerhandbuch Seite 22