Carrier TP-NHP Bedienungsanleitung PDF herunterladen (Seite 17)

NOTE: The 2−wire pigtail is not intended to support the weight of the User

Interface. Do not hang the User Interface from the equipment Control Module

screw terminals.

 Red is V+

 Black is Vg

7. Push any excess wire into wall and against mounting base. Seal hole in

wall to prevent air leaks. Leaks can affect operation and cause incorrect

temperature measurement.

8. Make sure to attach 2−wire pigtail to Display Module mounting base. It is

packed loose in the box from the factory. Then attach 2−wire pigtail to the

back of the Display Module via 2 pin, keyed connector.

9. Reattach Display Module body to mounting base by first setting on at top

of mounting base and then push bottom corners of Display Module to

snap into place. See Fig. 10.

A07168

Fig. 10 − Attach Display to Backplate

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Keine Kommentare

Carrier TP-NHP Bedienungsanleitung Seite 17