Carrier WIRELESS TRANSCEIVER 33CNWIRMOD Spezifikationen

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.PC 1

10USER FUNCTIONS — To change the password as a user:1. Select Change Password from the File menu. Changepassword dialog appears. See Fig. 15.2. Enter

11Session Holdoff — (Adjustment of these settings is notrecommended.)This will only be enabled for a host transceiver and is re-quired to manage the c

12Test Communications Between Units:1. Open the Configuration Manager. See Fig. 17.2. Click the Terminal Mode tab.3. In Test String, enter some text.4

13Fig. 18 — RX Configuration WindowFig. 19 — Loopback Test Window

14TROUBLESHOOTING (See Table 7)Table 7 — TroubleshootingSystem Configuration — Refer to the following tocheck system configuration:• Do the power and

15Q: Should I incorporate lightning surge protection for mytransceiver?A: It is a good idea whenever your coaxial cable lengths are20 feet or more. Co

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.PC 1

2PREINSTALLATIONEvery installer should perform site evaluation prior toinstalling the transceivers. In order to perform this evaluationthe following m

3Table 1 — Hardware SpecificationsSerial Communications — In order to configure anytransceiver, a 9-pin RS-232 cable must be used. This is neces-sary

4Table 2 — Stand-Alone Transceiver Pin Out Antenna Installation — Antennas must be connectedto each transceiver for proper operation. Without an anten

5NOTE: Not recommended for use on sites with secondary buses.Fig. 3 — Wireless Multiple Bus Extensions of Primary BusNOTE: Not recommended for use on

6Wireless links can only be used to extend a CCN primarybus (bus D). Do not use bridges when using a wireless link.Utilizing this primary bus wireless

7k. Repeat as necessary for more transceivers.l. Check Report Generation.m. Click Close.n. Click Cancel.o. Select Exit from the file menu.6. View the

8Modifying Settings — You can run the Quick Configu-ration wizard to modify settings or you can change entriesmanually in the fields in the modificati

9Generating Reports — Reports can be generated dur-ing the Quick Configure (if the box was checked) or can begenerated at any time using menu commands