Carrier HRVXXLVU1330 Bedienerhandbuch PDF herunterladen

HRVXXLVU

Installation Instructions

HEAT RECOVERY

VENTILATOR

A12520

HRVXXLVU

NOTE: Read the entire instruction manual before starting the

installation.

SAFETY CONSIDERATIONS

Improper installation, adjustment, alteration, service, maintenance,

or use can cause explosion, fire, electrical shock, or other

conditions which may cause death, personal injury or property

damage. Consult a qualified installer, service agency or your

distributor or branch for information or assistance. The qualified

installer or agency must use factory--authorized kits or accessories

when modifying this product. Refer to the individual instructions

packaged with the kits or accessories when installing.

Follow all safety codes. Wear safety glasses, protective clothing,

and work g loves. Have a fire extinguisher available. Read these

instructions thoroughly and follow all warnings and cautions

included in literature and attached to the unit. Consult local

building codes and the current edition of the National Electrical

Code (NEC) NFPA 70.

In Canada, refer to the current editions of the Canadian Electrical

Code CSA C22.1.

Recognize safety information. When you see this symbol

the unit and in instructions or manuals, be alert to the potential for

personal injury. Understand the signal words DANGER,

WARNING,andCAUTION. These words a re used with the

safety--alert symbol. DANGER identifies the most serious hazards,

which will result in severe personal injury or death. WARNING

signifies hazards, which could result in personal injury or death.

CAUTION is used to identify unsafe practices, which may result

in minor personal injury or product and property damage. NOTE

is used to highlight suggestions which will result in enhanced

installation, reliability, or operation.

INTRODUCTION

The Heat Recovery Ventilator (HRV) is used to exchange indoor

stale air with outside fresh air. The HRV unit is equipped with a

special heat recovery core which transfers sensible heat between

the fresh incoming air and stale exhaust air.

It is required to locate the HRV in a conditioned space. Special

attention should be given to condensate drain, duct application,

balancing the HRV, and locating unit for easy access and routine

maintenance. The cross--flow design core allows entering and

leaving air streams to transfer heat energy without mixing.

LOCATION

Inspect Equipment

Move carton to final installation location. Remove the HRV from

carton taking care not to damage unit. Remove all packaging and

inspect unit for damage. Remove parts bag from inside unit. File

claim with shipping company if shipment is damaged or

incomplete.

1 2 3 4 5 6 ... 13 14

Inhaltsverzeichnis

Seite 1 - Installation Instructions

HRVXXLVUInstallation InstructionsHEAT RECOVERYVENTILATORA12520HRVXXLVUNOTE: Read the entire instruction manual before starting theinstallation.SAFETY

Seite 2 - UNIT INSTALLATION

10CONTROL BOARD OPERATIONBoard FunctionNOTE: To ensure proper operation of HRV, configurationjumpers are located on electronic control board and must

Seite 3 - Condensate Drain

11TROUBLESHOOTINGELECTRICAL SHOCK HAZARDFailure to follow this warning could result in personal injuryor death.Before installing or servicing system,

Seite 4 - WALL CONTROL

12Be sure to unplug and inspect the unit before proceeding with these steps. Start with problem 1, then problem 2 and so on.Table 7 – TroubleshootingP

Seite 5 - OPERATING THE HRV WITH THE

13Override TestTo use override test function, a thermistor must be connected to thecontrol board. Unit must not be in defrost mode during an overridet

Seite 6 - ACCESSORIES

14If defrost is not working properly, check for proper damperoperation. To do this, turn unit to OFF position. Damper shouldclose.Safety FeatureThis n

Seite 7 - BALANCING HRV

2COMPONENT DESCRIPTIONThe following listed items are components of HRVXXLVU. SeeFig. 1).1281314963112151047A12505Fig. 1 -- HRVXXLVU Components1. Stale

Seite 8 - VENTILATION EVALUATION

3A12454Fig. 4 -- Exhaust VentilationCARBON MONOXIDE POISONING HAZARDFailure to follow this warning could result in personal injuryor death.Do not inst

Seite 9 - CONNECTION DIAGRAM

45. Connect unit drain to building’s main drain. Provide slightslope from unit for run-- off.A12456Fig. 5 -- Condensate Drain With Loop TrapLocate and

Seite 10 - CARE AND MAINTENANCE

5Ta ble 3 – Standard ControlMODEDEHUMIDISTATPOSITIONOPERATIONDAMPERPOSITIONFAN SPEED ON LEDAIR EXCHANGELEDOff Any Off Closed to outside Off Off OffLow

Seite 11 - TROUBLESHOOTING

6Cooling:AUTO -- the ventilator selects the speed based on indoor humidityand outdoor temperature. It may cycle on/off every 30 minutesdepending on hu

Seite 12

712”(300mm)FLOWCOLLARFRONTFRESH AIRFROM OUTSIDESTALE AIRTO OUTSIDETEMPORARYFLOW COLLARTEMPORARYFLOW COLLARRIGHT SIDE VIEWwith vertical ductsRIGHT SIDE

Seite 13 - Defrost Cycle

812” (304 mm)12” (304 mm)36” (914 mm)36” (914 mm)ORBAF GA12452Fig. 1 2 -- Balancing HRVXXLVUMeasure exhaust air first, it is typically the lowest pres

Seite 14 - Error Signaling

9WARNINGELECTRICALSHOCK HAZARDDisconnect power before servicing / maintenance or field wiring. Reinstall all panels before operating. Failure to do s

Kommentare zu diesen Handbüchern

Keine Kommentare

Carrier HRVXXLVU1330 Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Haushaltsfans Carrier HRVXXLVU1330 herunter. Carrier HRVXXLVU1330 Instruction manual [en] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Haushaltsfans Carrier HRVXXLVU1330