Part number 20083, Rev 0 1 PREMIERE CHROMATOGRAPHY REFRIGERATORS ABT-19C, ABT-23C, ABT-26C, ABT-33C, ABT-35C, ABT-37C, ABT-41C, ABT
Part number 20083, Rev 0 10 The STATUS tricolor LED shows the status of the unit. Green = normal run mode Amber = program mode Red = temperature is
Part number 20083, Rev 0 11 BASIC OPERATION The Control Center Monitor has two modes: NORMAL RUN MODE and PROGRAMMING MODE. In Normal Run mode, th
Part number 20083, Rev 0 12 Testing the battery: The battery recharges when the unit is plugged into line power. To test the battery, push the ALAR
Part number 20083, Rev 0 13 rd (Relay Delay) If there is an alarm condition, the relay contacts will switch. The relay delay parameter allows the u
Part number 20083, Rev 0 14 DIGITAL MICROPROCESSOR TEMPERATURE CONTROLLER Product Description The digital microprocessor temperature controller is
Part number 20083, Rev 0 15 Programming Procedure Display Description Display To start programming, press the SET key once to access the Fahren
Part number 20083, Rev 0 16 Error Messages Display Messages Corrective Action E1 Appears when either the up or down key is pressed when not in t
Part number 20083, Rev 0 17 QUICK TROUBLESHOOTING GUIDE Check these items before calling for service PROBLEM: POSSIBLE CAUSE / SOULTIONS: Unit does
Part number 20083, Rev 0 18 PROBLEM: POSSIBLE CAUSE / SOULTIONS: Compressor noises • Compressor may be overheated. Please check the room temp and
Part number 20083, Rev 0 19 MAINTENANCE AND CLEANING CLEANING PART CLEANING AGENTS TIPS AND PRECAUTIONS Interior and Door Liners Soap and water Bak
Part number 20083, Rev 0 2 TABLE OF CONTENTS RECEIVING ...
Part number 20083, Rev 0 20 CONDENSER MAINTENANCE IMPORTANT WARRANTY INFORMATION • Air is pulled through the condenser continuously during operat
Part number 20083, Rev 0 21 HORIZON SCIENTIFIC, INC. PRODUCT WARRANTY Horizon Scientific, Inc. warrants to the original purchaser every new Horizon
Part number 20083, Rev 0 22 WARRANTY IS NOT TRANSFERABLE. This warranty is not assignable and applies only in favor of the original purchaser/user
Part number 20083, Rev 0 3 RECEIVING Your unit was built, packaged, and inspected with extreme care. We shipped it to you using carriers we trust w
Part number 20083, Rev 0 4 INSTALLATION INSTRUCTION REQUIRED TOOLS – 9/16” socket or wrench, ¾” open end wrench, Phillips head screwdriver, and le
Part number 20083, Rev 0 5 For Sliding Doors Model – Remove the styrofoam blocks on the top of the door tracks (see Image 3) and the plastic door
Part number 20083, Rev 0 6 LEVELING – Proper leveling of your refrigerator is critical to operating success. Condensate removal and door operation
Part number 20083, Rev 0 7 SHELF INSTALLATON Hook shelf clip onto pilaster strips (See below). Position all four shelf clips equal in distance from
Part number 20083, Rev 0 8 REFRIGERATOR OPERATION After the unit is properly installed and power is applied, it will take some time before the syste
Part number 20083, Rev 0 9 CONTROL CENTER -- Temperature Monitor System The temperature control center (monitor) system on the front of the unit p
Kommentare zu diesen Handbüchern